Monico CDL Specifikace stáhnout pdf (Strana 5)

v1.05

6.26.09

- 5 -

CAUTION

Reversing wire polarity may cause damage to your Gateway. This damage is not

covered by warranty. If in doubt about which wire is which on your power supply,

check with a meter.

If you must use an external power supply, it is very important that the power supply is mounted

correctly if the unit is to operate reliably. Please take care to observe the following points:

– The power supply must be mounted close to the unit, with usually not more than 6 feet (1.8

m) of cable between the supply and the Gateway. Ideally, the shortest length possible should

be used. The wire used to connect the Gateway’s power supply should be at least 22-gage

wire. If a longer cable run is used, a heavier gage wire should be used. The routing of the

cable should be kept away from large contactors, inverters, and other devices which may

generate significant electrical noise.

– A power supply with a Class 2 or SELV rating is to be used. A Class 2 or SELV power

supply provides isolation to accessible circuits from hazardous voltage levels generated by a

mains power supply due to single faults. SELV is an acronym for “safety extra-low voltage.”

Safety extra low voltage circuits shall exhibit voltages safe to touch both under normal

operating conditions and after a single fault, such as a breakdown of a layer of basic

insulation or after the failure of a single component has occurred.

1 2 3 4 5 6 7 8 9 10 ... 45 46

Žádné komentáře

Modelos	Tipo de documento
40050	Instrucciones de operaciones Swordfish 40050 pencil sharpener, 1 paginas
40051	Instrucciones de operaciones Swordfish 40051 pencil sharpener, 1 paginas
40052	Instrucciones de operaciones Swordfish 40052 pencil sharpener, 1 paginas
40100	Instrucciones de operaciones Swordfish 40100 pencil sharpener, 1 paginas
40103	Instrucciones de operaciones Swordfish 40103 pencil sharpener, 1 paginas
40104	Instrucciones de operaciones Swordfish 40104 pencil sharpener, 1 paginas
40233	Instrucciones de operaciones Swordfish 40233 pencil sharpener, 1 paginas
40235	Instrucciones de operaciones Swordfish 40235 pencil sharpener, 1 paginas
40245	Instrucciones de operaciones Swordfish 40245 pencil sharpener, 1 paginas
40906	Instrucciones de operaciones Swordfish 40906 pencil sharpener, 1 paginas
Ebony-8	Instrucciones de operaciones Swordfish Ebony-8, 1 paginas
Varipoint Pencil Sharpener	Instrucciones de operaciones Swordfish Varipoint Pencil Sharpener, 1 paginas

Monico CDL Specifikace Strana 5